There are front (handles, locks, legs), and mounting accessories (ties, clamps, hinges, joints, drawers slides, etc.). Especially a lot of various fittings in the kitchens, where all these loops, railings, brackets, dampers, coils and other content provided almost half of all consumer properties.
«MAKURA» presents the following accessories:
- Edge banding materials;
- furniture hinges;
- hooks;
- metal furniture handles;
- metalboxes and slides (drawer slides and ball bearing slides);
- fixing materials;
- hardware: cable ties, screws, dowels, plugs, shelf;
- chrome-plated tubes for shop equipment.
Drawer slides are most often encountered two types - roller and ball bearing.
Roller drawer slides appeared in the domestic market in the early 90's, and at first were unaccustomed, seemed too expensive. Now almost no one piece of furniture is not without their use.
The main advantages of these slides - they are easy to move, require no lubrication, are fixed with just a few screws without sampling any special grooves or holes, can be mounted symmetrically on both sides of a vertical wall, do not impose stringent accuracy requirements on construction of the shell of the drawer, sensitive to distortions of the case at improper installation of products on the floor, make it possible to adjust the position of the front wall of a drawer in the three coordinates (height, width and depth) available in a wide range of lengths, make it easy to remove and install the box, provide its independent reach in fully closed position with a distance of 3-5 cm, can provide a complete nomination box can strengthen its bottom, without cutting the grooves in the sidewalls are relatively inexpensive.